The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data. The only real downside of this sensor is you can only get new data from it once every 2 seconds, so when using our library, sensor readings can be up to 2 seconds old.
Source : Adafruit (bit.ly/2dgEt3f)
Latest posts by Bikash Panda (see all)
- Firmata protocol with Raspberry Pi and Arduino - September 13, 2017
- IOT:Power outlet controlled from internet using WeMOS - August 9, 2017
- OSMC on Raspberry PI with Setup and Control using Android App - July 7, 2017